Table of Contents
Advertisement
Modem LED and Green WLAN LED. The Red Error LED should not be lit. At times, the Green
Status LED will blink while the others above are solid, this is normal. See below for more
information:
Power (Red)
Status (Green)
On
On
On
On
On
On
Signal strength of the SIM card can be confirmed using the table below.
Green LED 1
Off
On
On
On
5.3 SIM Card Setup
The cellular node is preconfigured for the AT&T SIM card included in the router. SIM card
replacement or tampering is not recommended, as it has been specifically configured for this
application.
IMPORTANT: If the following steps are not completed, service to the SIM card will be cancelled.
Register the SIM card in this device by emailing support@versichargesg.com the following
information: 1. Serial number(s) of VersiComm(s) that have been purchased (located inside the
front cover of the unit(s) on the "Rating Label" as seen in the picture below) 2. Address of
installation for VersiComm(s) 3. Company name of purchaser 4. Siemens account number (if
available) 5. Email, phone number, and contact name for future data plan billing purposes.
Unrestricted
16
Warn (Yellow)
On
On
Blinking
On
Blinking
Blinking
Blinking
Off
Blinking
Blinking
Blinking
On
Green LED 2
Off
Off
On
On
©
2019 Siemens Industry, Inc.
Error (Red)
Off
Off
Off
Off
Blinking
Blinking
Green LED 3
Off
Off
Weak Signal Strength
Off
Good Signal Strength
On
Strong Signal Strength
Description
Powered On
Power on Success
Dialing
Dialing success
Upgrading
Reset Success
Description
No Signal
814205 Rev02
Advertisement
Table of Contents
