Advertisement
Quick Links
Advertisement
Related Manuals for ZKTeco TL100
Summary of Contents for ZKTeco TL100
- Page 1 Installation Instruction TL100 Fingerprint Lock With Touch Keypad...
-
Page 2: Before Installation
Before Installation Diagram... -
Page 3: Packing List
Packing List Wooden Door Security Door 45mm 30mm 55mm 60mm 45mm 70mm 15mm 10mm 20mm 85mm 55mm 60mm 65mm 85mm 85mm 70mm 105mm... -
Page 4: Door Preparation
Door Preparation 1. Check door thickness, prepare the proper screws and spindles. Door Thickness D Spindle L Spindle J Screw K Screw 65 mm 30 mm 45-50 mm 45 mm 60 mm 50-60 mm 55 mm 85 mm 45 mm 55-65 mm 60 mm 55 mm... - Page 5 2. Check door open direction. Left Inward Right Inward Left Outward Right Outward Note : 1. Please install the mortise and strike plate according to the above pictures. 2. Mortise(E) can be applied to different door open directions by adjusting the direction of latch bolt.
- Page 6 Tips 1. How to change the direction of latch bolt? Step1: Push the switch to the end Step2: Push the latch bolt into the mortise Step3: Rotate the latch bolt at 180° inside mortise, then loose it. Œ Ž 180°...
- Page 7 3. How to use mechanical key ? 4. How to use emergency power? Insert the key into key hole and rotate 90°, then press down the handle to open the door. 9V Battery 5. How to change the location of stud bolts? Note: After holes are drilled on the door, you can adjust stud bolts location to make the lock suitable.
- Page 8 Step2: Twist down the Note: There are four square holes Note: There are two round other stud bolt. to be used. holes to be used.
- Page 9 Cautions 1. New lock is configured to grant ANY fingerprint access to unlock. 2. Please register one administrator at least for the new installed lock, If there is no any administrator, registration for normal users and temporary users are not allowed. 3.
-
Page 10: Installation
Installation 1. Drill holes on the door 2. Install the mortise(E) door thickness 45~90mm center line of the handle desired handle height Note 1: Align the template along the vertical center line of the mortise (E) at the desired handle height, and tape it to door. Note 2: Mark the holes first, then start drilling. - Page 11 3. Install outdoor unit(B) with gasket(C),and spindle(D) Note: 1. The small triangle must be placed toward the letter of R or L. 2. When the small triangle is towards to R, it is right open. 3. When the small triangle is towards to L, it is left open. Right Open Left Open Step1...
- Page 12 4. Install mounting plate (I) with gasket(C), and spindle(L) Tighten screws to fix the spindle. Step1 Step2 Step3...
- Page 13 6. Install battery (O) 5. Install indoor unit (M) Note: Push cable into the hole.
- Page 15 7. Mark and drill holes for strike...
- Page 16 8. Test the lock by mechanical key(A) or registered fingerprint Key A Key B Mechanical Key Instruction: 1. Key A is coated with brass color, which is used only for lock installer and upfitter. 2. Key B is packed in the sealed plastic wrap for safety, which is used for house owner.