Interlogix AS272 Installation Sheet page 2

Jumpers
J1: Siren
J2: Buzzer
J3: Beacon (AS273 only)
Jumper settings
Position Input level
0 V
1. Input disabled
2. Not active
3. Active
Specifications
Using without battery
Supply (limited 10 to 14.2 V 
current)
Current consumption:
Siren/buzzer 120 mA at 12 V
active
Siren/buzzer +
beacon active
Tamper output
Sound output:
Siren
Buzzer
Frequency:
Siren
Buzzer
−25 to +55°C
Operating
temperature
−10 to +55°C
Relative humidity
Dimensions
IP rating (with sealed
cable entry)
Recommender
battery
Beacon (AS273 only)
Light output
Flash frequency
Spike suppression
network
IP rating (with sealed
cable entry)
Battery replacement or removal
Caution: Batteries can explode or cause burns
when incorrectly (dis)assembled or exposed to fire
or high temperatures.
Dispose of used battery according to battery directive
instructions and/or as required by local laws. Keep away from
children.
2 / 2
12 V Floating
Input disabled Input disabled
Active Active
Not active Active
Using with battery
12.8 to 14.2 V 
max. 5 A max. 5 A
(typical), 20 mA (idle)
230 mA at 12 V (typical)
80 mA, 30 V
101 dB at 1 m (typical)
100 dB at 1 m (typical)
2.2 to 2.8 kHz (typical)
2 kHz
0 to +45°C
EN 50131:
EN 50131: 93% max.
155 × 114 × 44 mm
IP30 IK02
BS170-N: 9 V, 1700 mAh Lithium
Unchargeable
100 000 peak lumens
1 Hz
Standard fitted
IP30 IP02
To replace batteries, disconnect the battery from the siren.
Only replace the battery with the recommended battery. Do not
use a different type of batteries. Use of any other batteries may
present a risk of fire or explosion.
Regulatory information
Manufacturer
PLACED ON THE MARKET BY:
UTC Fire & Security Americas Corporation, Inc.
3211 Progress Drive, Lincolnton, NC, 28092, USA
AUTHORIZED EU REPRESENTATIVE:
UTC Fire & Security B.V.
Kelvinstraat 7, 6003 DH Weert, Netherlands
Product warnings THESE PRODUCTS ARE INTENDED FOR SALE
and disclaimers TO AND INSTALLATION BY QUALIFIED
PROFESSIONALS. UTC FIRE & SECURITY
CANNOT PROVIDE ANY ASSURANCE THAT
ANY PERSON OR ENTITY BUYING ITS
PRODUCTS, INCLUDING ANY "AUTHORIZED
DEALER" OR "AUTHORIZED RESELLER", IS
PROPERLY TRAINED OR EXPERIENCED TO
CORRECTLY INSTALL FIRE AND SECURITY
RELATED PRODUCTS.
For more information on warranty disclaimers and
product safety information, please check
https://firesecurityproducts.com/policy/product-
warning/
Certification
EN 50131-4, Security Grade 2, Environmental
class II (Pry-off tamper is not certified for an
EN 50131 Security Grade 2 applications.)
Tested and certified by Applica Test &
Certification.
AS272 and AS273 are certified for EN 50131-4
only if used without a battery.
2012/19/EU (WEEE directive): Products marked
with this symbol cannot be disposed of as
unsorted municipal waste in the European Union.
For proper recycling, return this product to your
local supplier upon the purchase of equivalent
new equipment, or dispose of it at designated
collection points. For more information see:
www.utcfssecurityproducts.eu/recycle/
This product may contain a battery that cannot be
disposed of as unsorted municipal waste in the
European Union. See the product documentation
for specific battery information. The battery is
marked with this symbol, which may include
lettering to indicate cadmium (Cd), lead (Pb), or
mercury (Hg). For proper recycling return the
battery to your supplier or to a designated
collection point. For more information see
www.utcfssecurityproducts.eu/recycle/
Contact information
www.utcfireandsecurity.com or www.interlogix.com.
For customer support, see www.utcfssecurityproducts.eu
P/N 142945999-4 • REV G • ISS 15DEC18
or scan the QR code.