Adcon addIT A720 Series User Manual page 48

48
CHAPTER 4
Performing Advanced Functions
Table 5. Command Code Definitions (Continued)
Code
0100 RBV – Read the specified bit.
0101
RNS – Read the notification
cation was pending, this command should
return an error. If one was pending, the notifica-
tion is cleared.
0110 DNOPC – Disable Notify On Port Change.
0111 ENOPC – Enable Notify On Port Change.
1000 RPNNER – Read the Pending Notifications and
the Notification Enable Register. This command
returns the 16-bit Pending Notifications and the
Notification Enable Registers; the Port Number
has no significance for this command.
1001 CB – Clear the specified bit.
1010 SB – Set the specified bit.
1011 XB – Exclusive Or the specified bit.
1100 MFR – Monostable function, start with the speci-
fied bit in OFF state (reset).
1101 MFS – Monostable function, start with the speci-
fied bit in ON state (set).
1110 MVFR – Multivibrator function, start with the
specified bit in OFF state (reset).
1111 MVFS – Multivibrator function, start with the
specified bit in ON state (set).
Description
a
status. If no notifi-
Parameters
The port number. Bit value and the result
(OK or ERROR).
The port number. Returns the time of the
last port change in stan-
dard time format and the
result (OK or ERROR).
The port number. Result (OK or ERROR).
The port number. Result (OK or ERROR).
None. Two 16-bit integers (first
the PN and then the NE
register) and the result
(OK or ERROR).
The port number. Result (OK or ERROR).
The port number. Result (OK or ERROR).
The port number. Result (OK or ERROR).
The port number, Result (OK or ERROR)
the OFF and the
ON times (in sec-
onds), both as 16-
bit integers.
The port number, Result (OK or ERROR).
the OFF and the
ON times (in sec-
onds), both as 16-
bit integers.
The port number, Result (OK or ERROR).
the OFF and the
ON times (in sec-
onds), both as 16-
bit integers.
The port number, Result (OK or ERROR).
the OFF and the
ON times (in sec-
onds), both as 16-
bit integers.
Returns