Advertisement
NOTE: These assembly instructions apply only to the catalog numbers listed below (SBE
Catalog
Number Application
6344
SBE80, SBE160, SBO60, SBX175
6305G1
SBE320, SBX350
6310G1
SBE320, SBX350
Contains two each of: housings, contacts, retaining pins, & cable ties.
1. Single conductors use #12 to #18 AWG wire only. Strip to 0.31 inch (7.9 mm) off end of insulation.
2. Twin conductor cable #12 to #18. Strip back outer jacket 5.50 inches (139 mm). (See illustration). Then strip
conductor insulation as in 1.
3a. To crimp: use the recommended tool. Crimping by other means may disturb contact position in housing and or
produce high resistance joints.
Crimp Tool
Manual - cycle controlled
Pneumatic - cycle controlled
3b. To Solder: Not recommended.
4. Thread or push one or two auxiliary contacts and wires through the rear of the connector before inserting into
auxiliary housings. Push into auxiliary housings through rear until notched side of contact tip snaps over spring.
Tug wires to make sure wires are secure.
5. Slide two auxiliary Powerpole
separately into SBE / SBX housing. The rear of each of the Powerpole housings must be flush.
6. Slide stacked auxiliaries back into connector housing until seated. The male dovetail should be on top as shown
in Figure 1. Make sure side grooves of auxiliaries are aligned for retaining pins and insert tubular pins. Tap pins in
holes from top, as shown in Figure 1.
SBX
Assembly Instructions
Catalog Number
1309G2
1367G1
housings together by dovetails to stack vertically. They cannot be inserted
®
Top
Male Dovetail
Auxiliary Contact
®
Wire
Contact Size
1331
#12/16
1331
#12/16
1332
#16/20
Retaining Pin
Figure 1
, SBX
, SBO
®
®
Retaining
Pin Length
0.85
1.00
1.00
).
®
Advertisement
