Troubleshooting - WAGNER PowerTex Owner's Manual

troUBleShootING

proBleM
Problem A: The sprayer does
not start.
Problem B: No material
coming from the sprayer.
Problem c: Application
speed too slow.
Problem d: sputtering/
intermittent flow.
Problem e: clumpy spray
pattern.
Problem f: Material leakage
at hopper connection.
wAGNer oNe-YeAr lIMIteD wArrANtY - keep oN FIle
This product, manufactured by Wagner Spray Tech Corporation (Wagner) is warranted against defects in material and
workmanship for one year following date of purchase if operated in accordance with Wagner's printed recommendations and
instructions. This warranty does not cover damage resulting from improper use, accidents, user's negligence or normal wear.
This warranty does not cover any defects or damages caused by service or repair performed by anyone other than a Wagner
Authorized Service Center.
ANY IMPLIED WARRANTY OF MERCHANTABlLITY OR FITNESS FOR A PARTICULAR PURPOSE IS LIMITED TO ONE YEAR FOLLOWING
DATE OF PURCHASE. THIS PRODUCT IS DESIGNED FOR HOME USAGE ONLY. IF USED FOR COMMERCIAL OR RENTAL PURPOSES,
THIS WARRANTY APPLIES ONLY FOR 30 DAYS FROM DATE OF PURCHASE. WAGNER SHALL NOT IN ANY EVENT BE LIABLE FOR
ANY INCIDENTAL OR CONSEQUENTIAL DAMAGES OF ANY KIND, WHETHER FOR BREACH OF THIS WARRANTY OR ANY OTHER
REASON. THIS WARRANTY DOES NOT APPLY TO ACCESSORIES.
If any product is defective in material and/or workmanship during the applicable warranty period, return it with proof of
purchase, transportation prepaid, to any Wagner Authorized Service Center. (A listing of Service Center locations is enclosed
with this product.) Wagner's Authorized Service Center will either repair or replace the product (at Wagner's option) and return
it to you, postage prepaid.
8
CAUSe
1. The sprayer is not plugged in.
2. The ON/OFF switch is set to OFF.
3. No voltage at wall plug.
4. The extension cord is damaged or has too low
a capacity.
5. There is a problem with the turbine.
1. Material too thick.
2. Nozzle too small for thickness of material.
3. Plugged or dirty sprayer.
1. Nozzle too small.
2. Plugged or dirty sprayer.
3. O-ring on turbine damaged, missing or dirty.
1. Hopper empty.
2. Plugged or dirty sprayer.
1. Material not sufficiently mixed.
1. O-ring on hopper damaged, missing or dirty.
eN
SolUtIoN
1. Plug the sprayer in.
2. Turn the ON/OFF switch to ON.
3. Properly test the power supply voltage.
4. Replace the extension cord.
5. Take sprayer to Authorized Service Center.
1. Thin the material by adding water.
2. Switch to a larger nozzle and/or thin the
material.
3. Thoroughly clean the sprayer.
1. Switch to a larger nozzle.
2. Thoroughly clean the sprayer.
3. Clean or replace the O-ring.
1. Fill the hopper
2. Thoroughly clean the sprayer.
1. Mix the material
1. Clean or replace the O-ring