Disclaimer - Genmitsu 3018-PRO User Manual

Disclaimer

Before operating your Desktop CNC Machine, please read the manual. Failure to do so may lead to personal injury, poor results,
or damage to the CNC Machine. Anyone who operates the Desktop CNC machine should know and understand the contents of
this manual.
SainSmart cannot control the conditions in which you assemble your Genmitsu CNC machine or verify if it was done properly.
We do not assume responsibility and expressly disclaim liability for loss, injuries, damage, or expense arising out of, or in any way
connected with the assembly, handling, storage, use, or disposal of the product.
The information in this manual is provided without any warranty, expressed or implied, regarding its correctness.
Please be careful when using your CNC machine. This machine is an electrical device with moving parts and
dangerous areas.
● Genmitsu CNC Machines are for Indoor Use Only.
● You must be 18 years or older to operate this machine, unless supervised by a knowledgeable adult familiar with the machine.
● Wear the proper Personal Protection Equipment (Safety Glasses etc.).
● Always place the CNC Machine on a stable surface.
● The SainSmart Genmitsu CNC Machine is supplied with Switchable Power Supply 230 VAC or 110VAC. Never use a different
power supply; it may cause malfunctions or damage to the machine.
● Ensure the Emergency stop button is easily accessible at all times.
● Never disassemble the Power Supply or Electrical Components. This will VOID the warranty.
● DO NOT TOUCH the machine spindle, or place any body part near the working area when the machine is operating. Serious
Injury may occur.
● DO NOT leave children unsupervised with the CNC Machine even when it's not operating. Injury may occur.
● DO NOT leave the machine unattended while it's operating.
● Ensure your CNC Machine is in a well-ventilated area. Some Materials may discharge smoke or fumes during operation.
03