IKEA LAGAN FC223/92 Manual page 12

ENGLISH
Problem
Water flows on the rear
plate of the refrigerator.
Water flows into the re-
frigerator.
Water flows on
ground.
The temperature in the
appliance is too low/
high.
If your appliance is still not working properly
after making the above checks, contact the Af-
ter Sales Centre. You can find the list at the end
of this manual.
Replacing the lamp
Caution! Disconnect the plug from the
mains socket.
1. Remove the
screw from the
lamp cover.
2. Pull outwards
the hook of the
lamp cover.
3. Remove the
lamp cover.
4. Replace the
lamp with one
of the same power (the maximum power is
shown on the lamp cover).
Possible cause
During the automatic defrost-
ing process, frost defrosts on
the rear plate.
The water outlet is clogged.
Products prevent that water
flows into the water collector.
the The melting water outlet does
not flow in the evaporative tray
above the compressor.
The temperature regulator is
not set correctly.
1
2
3
Solution
This is correct.
Clean the water outlet.
Make sure that products do not
touch the rear plate.
Attach the melting water outlet
to the evaporative tray.
Set a higher/lower temperature.
5. Install the lamp cover.
6. Tighten the screw to the lamp cover.
7. Connect the plug to the mains socket.
8. Open the door. Make sure that the light
comes on.
Closing the door
1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to the
assembly instructions.
3. If necessary, replace the defective door
gaskets. Contact the After Sales Service.
12