Blackmagicdesign HyperDeck Installation And Operation Manual page 28

You can use the control panel LCD menu on HyperDeck,
or use HyperDeck Setup to enable Start/Stop recording
The 'record trigger' settings let you set your HyperDeck to start and stop
recording triggered by data received over an HD-SDI connection
Timecode Run Recording
HyperDeck also supports timecode run recording, which is similar to start/stop recording, but is
only used if your HD-SDI camera does not support trigger recording via HD-SDI.
To set up timecode run recording using HyperDeck Setup:
1 Go into your camera's timecode settings and change them from 'free run timecode' to
'record run timecode'.
2 In HyperDeck Setup, set trigger recording to 'timecode run'.
3
Remote must also be enabled via HyperDeck's front panel or via the control panel
display menu on HyperDeck Studio Mini.
To set up timecode run recording on HyperDeck's control panel display menu:
1 Press the 'disp' or 'menu' button to display the main menu.
2 Scroll to the 'record' menu and press 'set'.
3 Scroll to the 'record trigger' menu and press 'set'.
4 Select 'timecode run' and press 'set' to confirm your selection. Press 'disp' or
'menu' to exit.
INPUT REM
JOG
DISP
SET
Codec Record Trigger
None
Record
Trigger
SDI Start/Stop
Timecode Run
Codec Record Trigger
INPUT REM
None
Record
Trigger
SDI Start/Stop
Timecode Run
JOG
Control Panel Display Menu 28