Tens Hi-Dow Instructions & User's Manual page 9

Battery Charging
Charging the Remote Using the AC Adaptor
Please fully charge the batteries in both the remote unit and TENS modules
before using this device.
Connect the small end of the USB cable to the remote and
the larger end to the AC adaptor (as shown in Fig 1)
Plug the adaptor into any standard mains socket.
Charging the TENS Modules
When the remote has finished charging the battery icon
indicates full.
9
Fig 1
Connect the USB cable as already described to the TENS
modules and plug the AC adaptor into any mains socket.
A red light indicates the TENS module is now charge
Charging your devices via a computer USB port
mode, once fully charged the red light will go out
CONTENTS & GENERAL INFORMATION
indicating that the TENS module is fully charged.
You may charge your TENS remote and tens modules
through a computer by using the USB port (See Fig 2).
Please note your computer must be switched on to
perform this function.
Fig 2
www.thetenscompany.co.uk Telephone: 0800 121 4626