Eastwood HIGH-CAPACITY TUBING BENDER Instructions Manual page 5

ratCHEt sub-assEMbLy
1. Place the Ratchet (o) between the spread blades of the Ratchet Lever (p) as
shown in (Fig 4) then pass the short M18 x 2.5" [50mm] Shoulder Bolt (Q)
through the blades of the Ratchet Lever (p) and Ratchet (o). Thread on
M18 Nut (F) then tighten.
instaLLing driVE LinK sub-assEMbLy
1. Back off the two M18 nuts out to the ends of the M18 bolts and spread the
Upper and Lower Frame Plates (a) & (b) sufficiently to allow the large 32mm
diameter holes to slip over the previously installed Brass Bushings up to their
flanges (Fig 5).
2. Slip the larger Ø 1" x 6-1/2" [Ø 25mm x 165mm] Pivot Pin (r) through
both Bushings.
3. Pull the Upper and Lower Frame Plates together with the INNER bolt finger
tight leaving the outer M18 bolt and Ø 1" x 4" [Ø 26mm x 102mm] Frame
Spacer out for now (Fig 5).
instaLLing ratCHEt/LEVEr sub assEMbLy in FraME
1. Place the Ø 1" x 4" [Ø 26mm x 102mm] Frame Spacer through the holes in
the Ratchet/Lever Sub-Assembly and slip one each of the Shaft Collars (s)
on either side with the Ratchet/Lever Sub-Assembly centered on the Frame
Spacer (Fig 6). Tighten the set-screws of the Shaft Collars (s) with a 4mm
hex key.
2. Insert the entire Ratchet/Lever Sub-Assembly between the Upper and Lower
Frame Plates then slip the M18 bolt (d) through both Frame Plates and
Ratchet/Lever Sub-Assembly (Fig 7).
Mounting HaZard!
Mounting to the optional Eastwood #21116 bender stand is
strongly recommended for proper operation and maximum
safety. if the unit is being attached to a properly and solidly
secured stand, do so now.
Mounting HaZard!
Failure to properly assemble and mount the bender stand to a
floor can cause sudden loss of control and serious injuries.
be sure all mounting bolts are securely tightened before use.
To order parts and supplies: 800.345.1178 >> eastwood.com
 """"
FIG. 4
o
 """"
FIG. 5
b
C
a
FIG. 6
Q
F
FIG. 7
Q
p
g
n
C
s
p
o
s
b
Q
p
F
o
C
a
n
5