Assembly - Weslo WLTL22191 User Manual

ASSEMBLY

Assembly requires two persons. Set the treadmill in a cleared area and remove all packing materials; do not
dispose of the packing materials until assembly is completed. Note: The underside of the treadmill walking
belt is coated with high-performance lubricant. During shipping, a small amount of lubricant may be transferred to
the top of the walking belt or the shipping carton. This does not affect treadmill performance. If there is lubricant
on top of the walking belt, simply wipe off the lubricant with a soft cloth and a mild, non-abrasive cleaner.
Assembly requires the included allen wrench
adjustable wrench
Refer to the drawings below to identify the parts used in assembly.
3/4Ó Screw (55)Ð14
1. With the help of a second person, carefully raise the
Uprights (14), the Console Base (6), and the Right
Handrail (57), until the treadmill is in the position shown.
Be careful not to pull on the Wire Harness (26).
Refer to the inset drawing. Insert one of the Extension
Legs (41) into the treadmill as shown. (Note: It may be
helpful to tip the Uprights [14] in the direction shown by
the arrow as you insert the Extension Leg. Make sure
that the Base Pad [36] is on the bottom of the Extension
Leg.) Attach the Extension Leg with an Extension Leg
Screw (34). Be sure to push on the head of the
Extension Leg Screw while tightening it.
Attach the other Extension Leg (41) in the same way.
2. Without removing the tape from the Latch (12), attach the
Latch to the left Upright (14) with four 3/4Ó Screws (55).
Make sure that the Screws are tight, but do not over-
tighten them; if the Screws are overtightened, the
Latch will not slide smoothly. After the Latch is at-
tached, remove any visible tape.
Note: The inset drawing shows how the parts of the Latch
(12) fit together.
and your own phillips screwdriver
.
Handrail Bolt (15)Ð4
5
Extension Leg
Screw (34)Ð2
1
6
2
14
Spacer
12
55
Bracket
and
Handrail Washer
(16)Ð4
26
57
14
14
34
41
36
Springs
Latch