Table of Contents
Advertisement
GENERAL WARNINGS
The machine must always be transported by professionally qualified personnel, taking care to avoid damage to any
part of the machine as a result of impacts or undue stresses caused by inappropriate lifting methods.
Damage to the machine caused during transport or handling is not covered by the guarantee. Repair and replacement
of damaged parts are the responsibility of the customer.
PACKAGING AND UNPACKING
•
Insert the forks of the lift truck (of suitable capacity) in line with the centre of
the box.
•
Make sure that the rear part of the package is free of obstacles.
•
Lift the box cautiously and transfer it to the location where it will be
unpacked, avoiding sudden harsh movements.
•
Ouvrir l' emballage et verifier l' intégrité de tout les composants. Garder
l' emballage pour des déménagements futurs.
•
Unscrew the screws A and lift the machine from the pallet.
•
Lift the machine, remove the brackets B and position it in the installation
area.
Installation area
The arranged area must be suitably illuminated and an electrical socket must be available. Place the machine
securely on a flat surface, in a horizontal position, with adequate weight bearing capacity, taking into account the
maximum weight of the machine. Ensure the machine is mechanically stable.
The resting surface must be sufficiently ample, even and dry. The machine must be installed in rooms with non-
explosive environments. In any case, installation must also be performed in consideration of the work safety laws in
force.
Descriptions
Working temperature
Storage temperature
Relative humidity
Dustiness
Electrical connections
DANGER – WARNING: Electrical connections to the supply
mains must be performed by specialised personnel.
Verify the efficiency of the grounding system in the building. Make sure that line
voltage (V) and frequency (Hz) correspond to those of the machine (See the
identification plate and wiring diagram). The machine is equipped with an
electrical cord that connects to a multi-polar plug. The plug is to be connected to
a wall switch equipped with a circuit breaker.
Room conditions table
0÷35 °C (32÷95 °F)
-15 to +65 °C (from –6.8 to +149 °F)
Maximum 80% with 20 °C room temperature
Maximum 50% with room temperature between 20÷60 °C
Less than 0.03 g/m³
HANDLING AND
INSTALLATION
Values
Advertisement
Table of Contents
