Safety Instruction - IKEA FÖRDELAKTIG Manual

ENGLISH

Safety instruction

General recommendations
• Never use scouring pads, steel wool, muriatic
acid or other products which could scratch or
mark the surface.
• For safety reasons, do not clean the appliance
with steam blasters or high-pressure cleaners.
• Foods that accidentally fall or settle on
the surface, on the functional or aesthetic
elements of the hob must not be eaten.
Cabinet requirements
• The cooking hob is intended to be built into
the worktop above a kitchen cabinet of 800
mm width or more.
• If fitting in flammable material, the guidelines
and standards for low voltage installations
and for the fire protection must be strictly
observed.
• For fitted units, the components (plastic
materials and veneered wood) must be
assembled with heat-resistant adhesives (min.
85°C): Unsuitable materials and adhesives can
result in warping and detachment.
• The kitchen cabinet must allow sufficient
room for the electrical connections of the
appliance. Suspended kitchen cabinets above
the appliance must be installed at a distance
that provides enough room for comfortable
working process.
• The use of hard wood decorative borders
around the worktop behind the appliance is
allowed, in this case the minimum distance
remains as indicated on the installation
illustrations.
• Positioning and dimensions of the cut-out for
built-in appliance is shown in the illustration
below. The measurements shown are
only valid if the following condition is met:
worktop overhang to cabinet front is 35mm.
• Minimum distance between built-in appliance
and any cabinet above it is 500mm.
+2
773 mm
+2
490 mm
555 mm
18 - 40mm
• To prevent leakage of liquid between the
edge of the hob and the countertop, place
the adhesive seal provided along the entire
outer edge of the hob before assembly.
Please refer to Assembly Instruction.
Electrical connection
• The wire connection has to be done by
specialized technician.
• This appliance has a Type "Y" attachment
and requires at least a power supply cord
Type H05VV-F. MONO-PHASE, BI-PHASE and
THREE-PHASE connection: min. section of the
conductors: 2,5 mm². External diameter of the
supply cord: min. 7 mm - max. 15 mm.
• Connection terminals are revealed when the
connection box cover is removed.
• Make sure the characteristics of the
household electrical system (voltage,
maximum power and current) are compatible
with those of the appliance.
• Connect the appliance like shown in the
diagram (in accordance with the mains
voltage and country standard reference).
• We suggest to use power supply cord 5 x
2.5 mm² H05V2V2-F, included in the package.
In case of use of power supply cord 5 x 2,5
mm² H05V2V2-F, below instructions have
to be followed: for three-phase connection
separate the 2 wires crimped together and
remove the light blue sheaths from grey
wires. Please refer to wiring diagram.
Use
• The extractor appliance has been designed
exclusively for domestic use to eliminate
kitchen smells.
• Never use the appliance for purposes other
than for which it has been designed.
• Deep fat fryers must be continuously
monitored during use: overheated oil can
Min. 500 mm
9