Advertisement
H7E-P
H7E-P
GENERAL INFORMATION
The terminals are solder-plated. Finish soldering the terminals
within 5 seconds, at a solder iron tip temperature of 250°±10°C
(482°F±50°F). Since the counter is not flux-tight, do not use
flux when soldering. Avoid automatic and dip soldering.
Manually solder the counter onto a PC board, and avoid
cleaning as much as possible.
When mounting the counter on a PC board with components
which consume higher current than the counter, place the
counter in the vicinity of the power supply. Avoid placing the
counter in a circuit with power-consuming components. Above
all, never place the count input circuit in a circuit common to
power-consuming components.
NOTE: DIMENSIONS SHOWN ARE IN MILLIMETERS. To convert millimeters to inches, divide by 25.4.
Omron Europe B.V. EMA-ISD, tel:+31 23 5681390, fax:+31 23 5681397, http://www.eu.omron.com/ema
Cat. No. GC CN4A
6/98/26M
Specifications subject to change without notice.
Printed in the U.S.A.
6
Advertisement
