REED ROCK MASTER A30HP Manual page 5

2. PRESSURE GAUGE – 3000 PSI
This hydraulic pressure gauge is used to indicate the hydraulic pressure of the
swing tube shift accumulator circuit.
3. EMERGENCY STOP
This is an emergency switch and is used to shut down the pump in an emergency
situation. It is of the push-pull type. Depress PUSH knob in to STOP operation. PULL
knob out to REACTIVATE system. NOTE – The HORN/RESET must be switched one
time to restart pump operation. If pump ON switch is ON it must be reset to OFF first.
4. CONTROL ON INDICATOR
This is a green indicator light, when lit denotes power is being supplied to control box.
5. HOURMETER
This instrument is used to record the number of hours the electric system has been
activated. The hourmeter becomes operational when the ignition key is ON.
6. ENGINE START SWITCH
This is a two (2) position key switch that is used to control the engine. Turn key to FAR
RIGHT position to engage starter; and then push ENGINE START button to start the
engine, key will put switch in SYSTEM ON position. To shut down engine, turn the key
counter-clockwise to SYSTEM OFF position.
7. PUMP ON INDICATOR LIGHT
This green light, located above the switch is used, when lit, to indicate the pump is on.
REVISION:
REED ROCK MASTER A30HP
TRAILER CONCRETE PUMP
OPER.
PAGE 04