Blanket Chamber Operational Procedures - Pedigo WARMWATCH P-2148 Operation & Care Manual

Blanket Chamber Operational Procedures

B L A N K E T
1. The appliance must be plugged into an appropriate
hospital grade receptacle as speci ed on the electrical
information page.
2. Turn on the power circuit breaker switch, which is
located at the back of the appliance. It is a rocker-type
switch with international ON (I) and OFF (O) markings.
3. ACTIVATE CONTROL BY PRESSING THE ON/OFF
BUTTON ON CONTROL PANEL ONCE.
The ON/OFF indicator will illuminate and remain lit until the unit is
turned off. The digital L.E.D. display will indicate last temperature
set-point of compartment.
4. SET DESIRED TEMPERATURE.
To set the blanket warming temperature, press and hold
the UP or DOWN ARROW buttons to change the value
shown in the display. The temperature set-point range is
37° - 93°C (98° - 200°F).
5. LOAD THE CHAMBER WITH 100% COTTON BLANKETS.
DO NOT WARM SYNTHETIC BLEND FABRICS OR ITEMS
CONTAINING PLASTIC, RUBBER OR METAL SNAPS,
STUDS, HOOKS, ETC.
Check that the epoxy-coated blanket support assembly and
shelf is in place. This blanket support assembly and shelf MUST
be used to hold blankets. A full load of blankets will take two to
three hours to reach optimum temperature. Make certain the
cabinet door is securely closed after initial loading and following
each blanket removal.
NOTICE: Do not block sensor by overloading cabinet with blankets.
6. ROTATE LOAD OF BLANKETS DAILY.
Rotate the blankets at the bottom of the load to the top to
ensure equal usage. Failure to rotate blankets can cause
blankets to discolor.
NOTICE: Avoid using ammable cabinet cleaning agents, as well as
blanket cleaning agents that cause fabric to become brittle
over time.
MM-1068 (MN-29617) • Rev 0 (10/15) • WarmWatch® Combination Blanket/Fluid Warmer • 12
C H A M B E R O P E R A T I O N A L
WA R N I N G
POWER
CIRCUIT BREAKER
SWITCH
N O T I C E : To enable the warming appliance to function
properly, DO NOT overload the interior. Allow
1" (25mm) gap between blankets and interior
of cavity and/or shelf.
Load blankets only to the top of
the blanket support assembly.
P-2140 Blanket
Warming Chamber
P R O C E D U R E S
To
prevent PERSONAL INJURY or
PROPERTY DAMAGE:
Blanket support assembly and shelf
must be in place when warming
blankets to prevent scorching or
discoloration.
P-2148 & P-2145 Blanket
Warming Chamber