General Information; Environmental Conditions - Baldwin Boxall OmniCarePLUS Multi-Exchange EVC Installation Instructions Manual

OmniCarePLUS Multi-Exchange EVC
Installation Instructions
G
ENERAL
! ! !
E
NVIRONMENTAL
viii
I
NFORMATION
Personnel who install, maintain or repair this equipment must
read the safety information below before starting work.
This Manual contains Warnings, Cautions and Notes.
Warnings describe potential threats to health or life, e.g.
W
ARNING
Before attempting to remove this component, ensure the Mains
Power Supply and Battery Backup have been disconnected.
Cautions describe potential threats to the equipment, e.g.
C
AU T ION
Notice must be taken of all cautions.
If a Caution is ignored the equipment may be damaged.
Notes are statements that are useful to the user in the context of
a particular section of the manual, e.g.
N : This is an example of a note.
OTE
C
ONDITIONS
This equipment must not be installed in an area that is subject to
a corrosive atmosphere, excessive moisture or may allow water or
other liquids to come into contact with the unit or its external
connections.Unless otherwise stated, all items are IP30.
AC Supply Voltage
DC Supply Voltage
Temperature (Operating &
Storage)
Humidity Range
In the close proximity of some radio frequency transmitting
devices, the signal to noise ratio of this product may be reduced.
If this occurs, re-location of the equipment or the signal cables is
recommended.
230V - 15% +10% RMS 50Hz AC
18V to 33V (Nominal 24V) DC
0°C up to +40°C
0% - 90% Non-Condensing
OmniCarePLUS issue 1