Charging The Battery Pack - Toro Power Plex 51481 Operator's Manual

Charging the Battery Pack

Important: Read all safety precautions.
Important: For best results, charge your battery pack
in a location where the temperature is more than 0°C
(32°F) but less than 50°C (122°F). To reduce the risk
of serious personal injury, do not store it outside or in
vehicles. Charging time increases if you do not charge
it within this range.
Note: At any time, press the battery-charge-indicator button
on the battery pack to display the current charge (LED
indicators).
1. Make sure that the vents on the battery pack are clear
of any dust and debris.
2. Line up the cavity in the battery pack
the tongue on the charger.
Figure 10
1. Battery pack cavity
2. Battery pack terminals
3. Battery pack venting areas
3. Make sure that the vents on the battery charger are
clear of any dust and debris.
4. Slide the battery pack into the charger until it is fully
seated (Figure 11).
(Figure 10) with
g192748
4. Battery-charge-indicator
button
5. LED indicators (current
charge)
1. Charger venting areas
2. Left indicator light
5. To remove the battery pack, slide the battery backward
out of the charger.
6. Refer to the following table to interpret the LED
indicators on the battery charger.
10
Figure 11
3. Right indicator light
g194423