Table of Contents
Advertisement
Charging the Battery Pack
Important:
The battery pack is not fully charged
when you purchase it. Before using the tool for
the first time, place the battery pack in the charger
and charge it until the LED display indicates the
battery pack is fully charged. Read all safety
precautions.
Important:
Charge the battery pack only in
temperatures that are within the appropriate
range; refer to
Specifications (page
Note:
At any time, press the battery-charge-indicator
button on the battery pack to display the current
charge (LED indicators).
1.
Ensure that the vents on the battery and charger
are clear of any dust and debris.
1. Battery pack cavity
2. Battery pack venting areas 6. Handle
3. Battery pack terminals
4. Battery-charge-indicator
button
2.
Line up the charger with the cavity on the back
of the battery pack
3.
Slide the charger into the battery pack until it is
fully seated
(Figure
4.
To remove the charger, slide the charger
backward out of the battery.
11).
Figure 11
5. LED indicators (current
charge)
7. Charger
(Figure
11).
11).
5.
Refer to the following table to interpret the LED
indicator light on the battery charger.
Indicator
Indicates
light
No battery pack inserted
Off
Green
Battery pack is charging
blinking
Green
Battery pack is charged
Red
Battery pack and/or battery charger is over or under
the appropriate temperature range
Red
Battery pack charging fault*
blinking
*Refer to
Specifications (page 11)
information.
Important:
The battery can be left on the charger
for short periods between uses.
If the battery will not be used for longer periods,
remove the battery from the charger; refer to
Storage (page
Advancing the Line Using
the Bump Feed
1.
Run the trimmer at full throttle.
2.
Tap the bump button on the ground to advance
the line. The line advances each time the bump
button is tapped. Do not hold the bump button
g330066
on the ground.
Note:
The line trimming cut-off blade on the
grass deflector cuts the line to the correct length.
Note:
If the line is worn too short, you may not
be able to advance the line by tapping it on the
ground. If so, release the trigger and refer to
Advancing the Line Manually (page
1. Bump button
13
for more
16).
Figure 12
14).
g331007
Advertisement
Table of Contents
