Charging The Battery Pack - Toro Power Plex 51491T Operator's Manual

1. Battery latch

Charging the Battery Pack

Important: Read all safety precautions.
Important: For best results, charge your battery pack
in a location where the temperature is more than 0°C
(32°F) but less than 50°C (122°F). To reduce the risk of
serious personal injury, do not store the battery pack
outside or in vehicles. Charging time increases if you do
not charge it within this range.
Note: At any time, press the battery-charge-indicator button
on the battery pack to display the current charge (LED
indicators).
1. Make sure that the vents on the battery are clear of any
dust and debris.
2. Line up the cavity in the battery pack
the tongue on the charger.
1. Battery pack cavity
2. Battery pack terminals
3. Battery pack venting areas
3. Make sure that the vents on the battery charger are
clear of any dust and debris.
Figure 6
(Figure
Figure 7
4. Battery-charge-indicator
button
5. LED indicators (current
charge)
4. Slide the battery pack into the charger until it is fully
seated
g194190
1. Charger venting areas
2. Left indicator light
5. To remove the battery pack, slide the battery backward
out of the charger.
6. Refer to the following table to interpret the LED
indicators on the battery charger.
Left Light
Off
7) with
Red
Green
Orange
Red Blinking
g192748
9
(Figure 8).
Figure 8
3. Right indicator light
Right Light Indicates
Charger is on; no battery
Red
pack inserted
Red Battery pack is charging
Red Battery pack is charged
Red Battery pack is too warm
Red Replace the battery pack
g194423