Table of Contents
Advertisement
Left Light
Right Light
Off
Red
Red
Red
Green
Red
Orange
Red
Red Blinking
Red
Advancing the Line
Note: The trimmer is equipped with an auto-feed head.
1. With the trimmer running, release the switch trigger.
2. Wait a few seconds, then press the lockout button and
squeeze the trigger.
Note: The line extends approximately 6 mm (1/4
inch) with each stop and start of the trimmer until the
line reaches the length of the grass deflector blade.
3. Resume trimming.
Advancing the Line Manually
Remove the battery from the trimmer, then push the button
at the base of the spool retainer while pulling on the trimmer
line to manually advance the line.
Figure 12
1. Button
Indicates:
Charger is on; no battery
pack inserted
Battery pack is charging
Battery pack is charged
Battery pack is too warm
Replace the battery pack
g203810
Adjusting the Handle Height
1. Loosen the lower shaft connector (A of
2. Slide the telescoping shaft to your desired position (B
of
Figure
13).
Important: Do not slide the upper shaft over the
vents on the lower shaft and do not remove the
rubber bumper.
3. Tighten the handle connector to secure the handle (C
of
Figure
13).
Adjusting the Auxiliary Handle
1. Release the auxiliary-handle latch (A of
2. Slide the auxiliary handle up or down to your desired
height (B of
Figure
Important: Do not remove the rubber bumper.
3. Close the auxiliary-handle latch to secure the auxiliary
handle in place (C of
11
Figure
Figure 13
Figure
14).
Figure
14).
Figure 14
13).
g203805
14).
g189875
Advertisement
Table of Contents
