Weider WESY38320 User Manual page 18

44. Wrap the VKR Low Cable (72) over a 3 1/2" Pulley
(78). Attach the Pulley and a Cable Trap (68)
between the lower set of holes in the "U"-bracket
(64) with a 3/8" x 2" Bolt (100) and a 3/8" Nylon
Locknut (87). Make sure that the Cable Trap is
turned to hold the Cable in the groove of the
Pulley.
45. Attach the end of the VKR Low Cable (72) inside of
the Short Base (2) with a 5/16" x 2 1/2" Bolt (59),
two 5/16" Washers (90), and a 5/16" Nylon Locknut
(86).
46. Locate the Squat Cable (73), which is the only
remaining cable. Attach the eyelet end of the
Cable inside of the Long Base (120) with a 5/16" x
2 1/2" Bolt (59), two 5/16" Washers (90), and a
5/16" Nylon Locknut (86).
47. Wrap the Squat Cable (73) over a 3 1/2" Pulley
(78). Attach the Pulley, a Cable Trap (68), and two
3/4" Spacers (124) between the indicated brackets
on the Squat Slider (38) with a 3/8" x 3 1/4" Bolt
(96) and a 3/8" Nylon Jamnut (113). Make sure
that the Cable Trap is turned to hold the Cable
in the groove of the Pulley.
44
45
86
90
46
59
47
73
18
100
64
68
87
72
78
72
90
2 59
73
86
90
120
90
78 68
113
124
124
38
96