Sharp 8M-B80AX1E Setup Manual page 9

Attaching the Stand (Continue)
 Positions when holding the product
• When lifting or carrying, hold the product by the positions in the illustration, not by the stand or panel
surface.
Connecting an 8K Video Device
Connecting with Four HDMI Cables (for 8K Output Compatible Device)
CAUTION
 Connecting to an 8K output compatible device
• It is very dangerous to remove the
• To connect the product to an 8K output (with 7680 x 4320
stand fixing screws while this Monitor is
resolution) compatible device, use four Premium HDMI Cables.
standing as it can result in toppling over
• Connect so that the output signals of the 8K output compatible
of this Monitor.
device are output to the proper positions.
• The display positions for the HDMI input terminals are shown
on the right.
• INPUT7 (A to D) are terminals dedicated for 8K input.
• 8K video input terminals are not supported for multi-display.
• When input signals to INPUT7 (A to D) are all synchronized,
• In the installation procedure, be careful not
8K display is available.
to catch your fingers between the Monitor
• By factory default, the Monitor uses the audio to INPUT7-A.
set and the floor.
• To change the setting, after switching to INPUT7, go to the Setup menu, select Setup >
• Do not remove the stand from the
Terminal setting > INPUT7 audio select, and then select a terminal to input audio.
Monitor unless using an optional wall
mount bracket to mount it. • Also refer to the operating instructions of the device to be connected.
• After attaching the stand to the
• Commercially available Premium HDMI Cables are necessary.
Monitor, do not hold the stand when
you put up, set up, move or lay down
the Monitor.
EN 3
To reduce loads on the
terminals and prevent
breakage, thread the HDMI
cables through the cable
clamps to secure.
8K output compatible device
Rear side of Monitor
INPUT7
(8K signal terminal)
INPUT7-A INPUT7-B
INPUT7-C INPUT7-D
(Option) >
Premium HDMI cable
(Commercial Item)