Sharp 8M-B120C Quick Start Manual

Sharp 8M-B120C Quick Start Manual

Hide thumbs Also See for 8M-B120C:

Advertisement

Quick Links

8M-B120C Dismantle Instruction
LCD MONITOR
8M-B120C
MODEL
Dismantle Instruction
1

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the 8M-B120C and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Sharp 8M-B120C

  • Page 1 8M-B120C Dismantle Instruction LCD MONITOR 8M-B120C MODEL Dismantle Instruction...
  • Page 2 8M-B120C Dismantle Instruction Table of contents 1. Scope ....................... 3 2. Tools for dismantling..................... 3 Dismantle Procedure .................... 3 4. Batteries ......................4 5. Back covers ......................4 6. Printed circuit boards ................... 5 7. LCD Module bezels/angles ..................6 8.
  • Page 3 8M-B120C Dismantle Instruction 1. Scope This document describes dismantling instruction according to Annex VII of Directive 2012/19/EU. 2. Tools for dismantling Below tools are required to dismantle this product. Screw Driver Nipper 3. Dismantle Procedure This product can be dismantled by below steps.
  • Page 4 8M-B120C Dismantle Instruction 4. Batteries This model uses only AAA battery for remote control. Battery can easily be removed. 5. Back covers 3 back covers (right/center/left) can be removed by screw driver.
  • Page 5 8M-B120C Dismantle Instruction 6. Printed circuit boards All PWBs can be removed by screw driver. Main PWB (1pcs) Power PWB (4pcs) Back end PWB(1pcs) Backlight Power Control PWB (1pcs) Main T-CON PWB (1pcs) Sub T-CON PWB (8pcs) LED Driver PWB (4pcs)
  • Page 6 8M-B120C Dismantle Instruction 7. LCD Module bezels/angles LCD Dismantle procedure 1. Remove screws (part 1) 2. Remove Corner Angle (part 9) and Bezels (part 8 and 10) 3. Remove screws (part 4 and 5) 4. Remove Middle Frame (Part 2, 3, 6, and 7)
  • Page 7 8M-B120C Dismantle Instruction 8. Capacitors Electrolyte Capacitors which diameter/height is larger than 25mm is installed on the Power PWB. These capacitors can be removed by using nipper to cut the leads. 9. Parts List Parts described in Annex VII of directive 2012/19/EU are as below.

Table of Contents