Frame Assembly - Weider 831.159830 User Manual

Frame Assembly

1. Before beginning, be sure that you have read
and understood the information on page 5.
Locate and open the parts bag labeled
"FRAME ASSEMBLY."
Press a 2" Square Inner Cap (67) into each end
of the Butterfly Base (1).
Insert four 5/16" x 2 1/2" Carriage Bolts (75) and a
a 3/8" x 3 1/2" Carriage Bolt (95) up through the
indicated holes in the Butterfly Base (1). Place the
Butterfly Base flat on the floor. Note: If the Bolts
fall out, secure them by putting a small piece of
tape over the head of each Bolt.
2. Press three 2" Square Inner Caps (67) into the
Center Base (2). Insert a 3/8" x 3 1/2" Carriage
Bolt (95) up through the indicated hole in the
Center Base.
Attach the Center Base (2) to the Butterfly Base (1)
with two 5/16" x 2 3/4" Bolts (89), a Medium
Support Plate (109), and two 5/16" Nylon Locknuts
(86). Do not tighten the Nylon Locknuts yet.
Note: There are three kinds of Support Plates.
The main difference between them is the dis-
tance between the holes. When you need a
Support Plate, find the kind with holes that
will fit over the bolts you are using.
3. Press a 2" Square Inner Cap (67) into the end of
the Press Base (3).
Insert four 5/16" x 2 1/2" Carriage Bolts (75) up
through the indicated holes in the Press Base (3).
Insert a 3/8" x 2 1/2" Carriage Bolt (76) and a 3/8"
x 4" Carriage Bolt (112) up through the indicated
holes at the end of the Press Base.
Attach the Press Base (3) to the Center Base (2)
with two 5/16" x 2 3/4" Bolts (89), a Medium
Support Plate (109), and two 5/16" Nylon Locknuts
(86). Do not tighten the Nylon Locknuts yet.
1
1
75
67
2
89
109
86
1
3
2
3
75
6
95
75
86
67
2
95
86
67
86
112
75
76
67
109
89