Weider 831.159380 User Manual page 11

17. Attach the Left Pull-up Arm (75) and the Right
Pull-up Arm (77) to the Assist Upright (74)
with two 5/16" x 2 3/4" Bolts (11) and two
5/16" Nylon Locknuts (3).
Attach the Left Dip Arm (78) and the Right
Dip Arm (79) to the Assist Upright (74) with
two 5/16" x 2 3/4" Bolts (11) and two 5/16"
Nylon Locknuts (3).
Wet the ends of the Left and Right Pull-up
Arms (75, 77) with soapy water. Slide a Long
Foam Handgrip (113) onto each Pull-up Arm.
Press two 1 1/4" Round Inner Caps (109) into
each Pull-up Arm.
Wet the ends of the Left and Right Dip Arms
(78, 79) with soapy water. Slide a Short
Handgrip (80) onto each Dip Arm. Press a
1 1/4" Round Inner Cap (109) into each Dip
Arm.
18. Locate and open the parts bags labeled
"CABLE ASSEMBLY" and "PULLEYS."
During steps 19 through 39, refer to the
CABLE DIAGRAMS on pages 26–27 of this
manual to verify proper cable routing. Before
beginning this section, fully unwind the four
Cables. Identify the four Cables by comparing
the lengths and ends of the Cables. The
approximate length of each Cable is listed (in
inches) after the key number in the drawing.
IMPORTANT: While assembling the cables,
do not overtighten the bolts and nuts
attaching the pulleys. The pulleys must be
able to turn freely.
19. Locate the High Cable (58). Wrap the High
Cable around a 3 1/2" Pulley (15). Attach the
Pulley to the Top Frame (55) with a 3/8" x
3 3/4" Bolt (88) and a 3/8" Nylon Locknut (21).
Be sure that the end of the Cable with the
ball is on the indicated side of the Pulley
and that the Cable is between the Pulley
and the hook.
17
113
109
80
109
18
19
55
21
Ball
Hook
11
74
75
11
77
109
11 113
78
80
109
23—79"
58—150"
72—192"
99—64"
58
88
15
3
3
109
3
79