Handlebar Switches - Yamaha MT-25 Owner's Manual

Instrument and control functions

Handlebar switches

Left
1
4
2
1. Pass switch "PASS"
2. Dimmer switch " /
3. Horn switch " "
4. Turn signal switch "
Right
1
2
1. Start/Engine stop switch "
/
2. Hazard switch "
EAU1234M
Pass switch "PASS"
Press this switch to flash the headlight.
TIP
When the dimmer switch is set
to "
fect.
Dimmer switch "
3
Set this switch to "
4
beam and to "
Turn signal switch "
"
To signal a right-hand turn, push this
/ " switch to "
turn, push this switch to "
released, the switch returns to the cen-
ter position. To cancel the turn signal
lights, push the switch in after it has re-
turned to the center position.
Horn switch "
Press this switch to sound the horn.
/ / "
"
", the passing switch has no ef-
/ "
" for the high
" for the low beam.
/ "
". To signal a left-hand
". When
"
4-10
EAU12362
Start/Engine stop switch "
To crank the engine with the starter,
set this switch to "
the switch toward "
for starting instructions prior to starting
the engine.
Set this switch to "
gine in case of an emergency, such as
EAU85410
when the vehicle overturns or when the
throttle cable is stuck.
Hazard lights switch " /OFF"
The hazard lights (simultaneous flash-
EAU12461
ing of all turn signal lights) are used in
case of an emergency, such as to warn
other drivers when your vehicle is
stopped where it might be a traffic haz-
ard.
Set this switch to " " to turn on the
hazard lights. To turn off the hazard
lights, set the switch to "OFF".
NOTICE
EAU12501
Do not use the hazard lights for an
extended length of time with the en-
gine not running, otherwise the bat-
tery may discharge.
EAU68270
/ / "
", and then slide
". See page 6-2
" to stop the en-
EAUN2210
ECA10062