Dometic ProSafe MD283 Installation And Operating Manual page 22

proSafe
➤ Press the ENTER button.
✓ The display shows the message REPEAT.
➤ Press the ENTER button.
➤ Repeat the entry of the new six digit anti-tamper code within ten seconds
➤ Press the ENTER button again.
✓ The safe confirms the change of the anti-tamper code with an audio tone.
Using the master key with the anti-tamper system
You can open the safe in any situation using the master key, even, for example, in the
event of an electronic fault.
A
NOTICE!
No unauthorised persons should have access to the master key.
Store the master key very carefully in a safe location.
➤ Remove the plastic cover concealing the key hole (fig. 1 5, page 3).
➤ Insert the master key into the lock.
➤ Open the safe by turning the master key 180° to the right (fig. 4, page 4).
✓ The display shows the message A-002.
✓ Turn the master key 180° to the left and remove the master key.
✓ The safe is blocked by the anti-tamper system.
I
NOTE
When you press the ENTER button on the blocked safe three short
beeps will sound. When you press ENTER again the display shows the
message CODE.
➤ Reattach the plastic cover.
EN
Using the safe
23