Hardware; Storage - Saft 4579 Component Maintenance Manual With Illustrated Parts List

B. Insert terminals of the adapter connector (16) (IPL Fig 1) through the oval mounting
hole in the front of the battery case (7) (IPL Fig 1).
C. Attach the adapter connector (16) (IPL Fig 1) to the battery case (7) (IPL Fig 1) with
sems screws (18) (IPL Fig 1). Secure the receptacle by tightening the screws (18)
(IPL Fig 1) per Fig 801.
4.

Hardware

Install the intercell connecting hardware using the following steps:
A. Recheck all cell polarities.
B. Mount the intercell connector links (11 through 15)(IPL, Fig 1).
(1)
(2)
(3)
(4)
5.

Storage

A. General
The storage room should have an atmosphere free of acid, dust, or dampness. No
corrosive liquids or gases should be stored in the same room. Temperatures may
range from -75°F (-60°C) to +140°F (+60°C) without harming the battery. The most
desirable range for long term storage is between 32°F (0°C) to 86°F (30°C).
SAFT AMERICA INC.
COMPONENT MAINTENANCE MANUAL
Replace any intercell connector links that are bent, burnt, or have defective
nickel plating.
Using a small brush, lightly coat cell terminals and intercell links with neutral,
nonacid, petroleum jelly.
NOTE: Excessive use of petroleum jelly on the terminals and connector
links will contribute to current leakage in high ambient
temperature operations. Extreme care should be exercised in
the use of this product.
Mount the washers (6) (IPL Fig 1) and upper nuts (5) (IPL Fig 1).
NOTE: Cell terminals should be lightly greased prior to installation of
nuts.
Torque upper nuts per Fig 801.
4579
24-31-05
PAGE 703
Jan 30/98