Battery Connector Receptacle - Saft 4579 Component Maintenance Manual With Illustrated Parts List

(3)
(4)
D. Install the left and right side row of cells and liners as follows:
(1)
(2)
(3)
(4)
3.

Battery Connector Receptacle

Install the main connector (16) (IPL Fig 1) in the case (7) (IPL Fig 1) using the following
steps:
A. Assemble connector gasket (17) (IPL Fig 1) to the adapter connector (16) (IPL Fig 1).
SAFT AMERICA INC.
COMPONENT MAINTENANCE MANUAL
Install liners (27.5 and 27.8) (Fig 702) into the center partition of battery case.
Install a cell assembly (2) (IPL Fig 1) into position 13 in the center partition of
the battery case (7) (IPL Fig 1). Insertion of the last cell is sometimes
difficult, and may be assisted by pushing down on the terminals with a small
block of softwood.
NOTE: Liners (27.1) (Fig 702) are used as required to ensure the center
row cells are retained securely in place. As indicated in Fig
702, the maximum quantity to be used is as shown.
Install liners (27.8, 27.5, 27.6 and 27.3) (Fig 702) into the battery case (7) (IPL
Fig 1) as shown in Fig 702.
Install six cell assemblies (2) (IPL Fig 1) in the left and right hand side of the
battery case (7) (IPL Fig 1). Be sure to maintain the proper cell arrangement
and polarity orientation per Fig 703.
Install the left and right end liners (27.8) (Fig 702) into the battery case (7)
(IPL Fig 1) at each end as shown in IPL Fig 702.
Install the remaining two cell assemblies (2) (IPL Fig 1) into the battery case
(7) (IPL Fig 1). Be sure to maintain the proper cell arrangement and polarity
orientation per Fig 703. Insertion of the last cell on each side is sometimes
difficult, and can be assisted by pushing down on the terminals with a small
block of softwood.
NOTE: Liners (27.1 and 27.2) (Fig 702) are used as required to ensure
the left and right hand row of cells are retained securely in
place. The maximum quantity to be used is shown in Fig 702.
4579
24-31-05
PAGE 702
Jan 30/98