Removing And Replacing Wheels; Front Wheel; Rear Wheel - neomouv NOVA S User Manual

2.3

Removing and replacing wheels

2.3.1
Removing the front wheel :
You must first loosen the wheel fixings.
-
Once this is done, the wheel must be slid forward to remove it.
-
Insert the plastic spacer into the calliper (between the two pads).
-
DO NOT SQUEEZE THE BRAKE LEVER WHILST THE WHEEL IS REMOVED.
-
Replacing the front wheel :
Carry out the assembly operations in reverse order. Make sure that the wheel attachment is tightened
-
and aligned.
Once the wheel is in place, operate the brake lever 3-4 times. This allows the pads to be properly
-
aligned.
Check that the brake disc is centred and rotates without friction.
-
Finally, check that the brakes are working properly.
-
2.3.2
Removing the rear wheel :
Loosen the quick-release clamp.
-
Pull the wheel forward and remove the chain from the wheel axle.
-
Insert a plastic spacer in the calliper (between the two pads).
-
DO NOT SQUEEZE THE BRAKE LEVER WHILST THE WHEEL IS REMOVED
Replacing the rear wheel:
Remove the plastic spacer from the calliper.
-
Take the wheel and place the chain on the small sprocket on the right side, then engage the wheel
-
between the brake pads.
Moving backwards, insert the wheel axle into the right and left housing of the frame. Tighten the quick
-
release.
Checking the wheel alignment :
Centre the wheel in relation to the frame.
-
Check the centring and positioning in line with the front wheel, as well as the positioning of the chain.
-

Front wheel :

Rear wheel :

Manuel NOVA S –MOUNTAIN S – ENARA S
:
6