Mounting And Dismounting The Wheels; Front Wheel; Rear Wheel - neomouv ELAIA User Manual

Mounting and dismounting the wheels:

2.5
 A ,
S A GENERAL RULE
T
HE WHEEL WILL BE VERY DIFFICULT TO REMOUNT SHOULD THIS HAPPEN

2.5.1 Front wheel:

Dismounting the front wheel:
- First, you must loosen the wheel's fastenings.
- Once this has been done, slide the wheel forward to remove it.
- Insert a piece of plastic in the calliper (between the two pads).
Mounting the front wheel:
- Carry out the dismounting operations in inverse order. Check the tightness of the wheel attachment and
its alignment.
- Once the wheel is in place, operate the brake handle 3-4 times. This allows the pads to settle correctly.
-
Check that the brake disc is properly centred and rotates without friction.
- Finally, check that the wheel brakes are working properly.

2.5.2 Rear wheel:

Dismounting the rear wheel:
- First, you must loosen the wheel's fastenings.
- Once this has been done, slide the wheel forward and remove the chain from the axle to remove it.
- Insert a piece of plastic in the calliper (between the two pads).
Mounting the rear wheel:
-
Remove the piece of plastic from the calliper.
- Take the wheel and place the chain on the small sprocket on the right-hand side, then place the wheel
between the brake pads.
- Insert the wheel axle backward into the housing on the left and right of the frame. Attach the washers
and the wheel nuts. Tighten the nuts by hand initially, until they make contact with the frame.
Checking the wheel alignment:
- Centre the wheel in relation to the frame.
- Check the centring and positioning in line with the front wheel, as well as the positioning of the chain.
- Screw on the wheel nuts on both sides without tightening them.
- Check the positioning, centring and position of the chain again.
Checking the brake adjustment:
-
Operate the brake handle 3-4 times. This allows the pads to settle correctly.
-
Check that the brake disc is properly centred and rotates without friction.
- Finally, check that the wheel brakes are working properly.
Alternately and progressively tighten the wheel nuts on each side (max. tightening torque 25 Nm)
Replace the nut covers.
NEVER OPERATE THE BRAKE LEVERS WHEN A WHEEL IS OFF THE BIKE
ELAIA Manual
8
.
.