Razor Pocket Mod Petite Owner's Manual page 10

REPAIR AND MAINTENANCE
Rear Wheel/Hub Motor Replacement
Tools Required: Phillips Screwdriver, 10 mm Wrench, Two (2) 8 mm Wrenches, and 17 mm Wrench
1
Locate and disconnect motor
from controller.
4
Using two (2) 8 mm wrenches,
loosen and remove the bolt and lock
nut from the cable guide bracket.
7
Thread the brake cable through
the brake adjuster barrel, through
the large spring, and into the small
hole in the side of the anchor bolt.
Position the cable to the original
location (as indicated by the slight
cable kink) and tighten securely.
Need Help? Visit our website for replacement parts, product support, a list of authorized service centers in the US and customer service contact information
at www.razor.com. Please have the product I.D. code (located on the white label of your product) available for better assistance. Additional Customer
Service contact information is listed at the back of this manual.
1.
3.
2.
2
Using a Phillips screwdriver,
loosen and remove three (3) screws
from motor cover.
5
With 17 mm wrench, loosen the
nut. Remove wheel/hub motor.
8
Repeat the steps in reverse
to reinstall.
3
With a 10 mm wrench, loosen the
brake cable anchor and disconnect
the cable.
20-8 Cable
Guide
Bracket
20-7 Nut
20-10 Bolt
20-7
Brake Plate
6
Install the cable guide bracket to
the frame and brake plate using bolt,
washers, and nut. Do not tighten.
*See the hardware sequence on
the right.
9
*Note the hardware sequence (from
outside toward the center).
Frame
Left Side (Brake)
20-1 17 mm Flange Locknut
20-2 Lock Washer
Frame
20-3 Spacer
20-4 Brake Plate
Right Side (Throttle)
20-5 Motor Cover
20-6 Screws (3)
*Note the hardware sequence
(from left to right).
20-7 Nut
20-8 Cable Guide Bracket
20-9 Brake Plate
Frame
20-10 Bolt