Table of Contents
Advertisement
Installation
IMPORTANT
This appliance must be installed and serviced by
a competent person as stated in the Gas Safety
(Installation and Use) Regulations Current
Editions and the IEE Wiring Regulations.
Any gas installation must be carried out by a
competent person to the relevant Gas
Standards.
The manufacturer will not accept liability,
should the above instructions or any of the
other safety instructions incorporated in this
book be ignored.
Connecting to Gas
This cooker is designed to be installed with an appliance
flexible connection. Connection is made to the RC 1/2
(1/2" B.S.P.) threaded entry pipe located just below the
hotplate level on the rear right-hand side of the cooker.
A second entry pipe is located on the rear left-hand side
and it is locked by a security nut. Should this second
entry pipe allow a safer gas connection, remove the
security nut and the relevant gasket from the left-hand
entry pipe and place it onto the main entry pipe, ensuring
the gasket is correctly positioned and the nut is well
secured.
When the final connection has been made, it is
essential that a thorough leak test is carried out
on the cooker and installation.
Ensure that the main connection pipe does not
exert any strain on the cooker.
Note:
For certain types of gas bayonet connection used, it may
not be possible for the appliance to be pushed fully back
to the wall stops.
Important:
Flexible tubing MUST comply with BS.669 Current
Edition.
26
FO 2411
A) End of shaft with nut
B) Washer
C) Elbow
Advertisement
Table of Contents
