Operation - Zanussi ZCM 700 Instruction Booklet

Operation

Hob Burners
"
To light a burner:
- turn the relevant control knob anticlockwise to
maximum position.
- At the same time push the electric ignition button
which is marked with a little spark.
- Upon ignition, keep the knob pushed down about
5 seconds, then adjust the flame as required.
If the burner does not ignite, turn the control knob to
zero, and try again.
When switching on the mains, after installation or
a power cut, it is quite normal for the spark
generator to be activated automatically.
To ensure maximum burner efficiency, you should only
use pots and pans with a flat bottom fitting the size of
the burner used (see table).
Burner
Large (rapid)
Medium (semi-rapid)
Small (Auxiliary)
Central (2 crown)
If you use a saucepan which is smaller than the
recommended size, the flame will spread beyond
the bottom of the vessel, causing the handle to
overheat.
As soon as a liquid starts boiling, turn down the
flame so that it will barely keep the liquid
simmering.
Take care when frying food in hot oil or fat, as the
overheated splashes could easily ignite.
If the control knobs become difficult to turn, please
contact your local Service Force Centre.
6
minimum maximum
diameter diameter
160 mm. 260 mm.
120 mm. 240 mm.
80 mm. 160 mm.
180 mm. 260 mm.