Zanussi ZCM 700 Instruction Booklet page 27

Fitting the Stability Bracket
(Not supplied)
If the cooker has to be installed with a flexible supply
pipe, it is necessary that a stability device is fitted.
If a stability bracket should be fitted by the installer, these
instructions should be read in conjunction with the leaflet
packed with the stability bracket.
"
1. Place the cooker in its intended position and
mark the cooker height.
2. Mark 165mm below the cooker height. This is
the position of the stability bracket.
3. Fix a large type of stability bracket (using two
of the provided five fixing holes) to the rear wall
(see the picture below).
4. Pull the cooker towards the rear wall as shown
in the diagram. The stability bracket should
then come into contact with the rear panel of
the cooker (see diagram).
Should the stability bracket currently installed not allow
the cooker to stand correctly, ask the installer to replace
it with the correct type.
27