Fm Radio Operation; Tuning In A Station; Audio Mode; Presetting Stations - JVC UX-D750 Instruction Manual

FM Radio Operation

• Make sure that you have correctly connected and fully extended the antenna.
• The search may not stop at a station with a very weak signal.
• If reception is still poor, try to adjust the DAB / FM aerial location.
Turn SOURCE dial on the unit or press FM/DAB button repeatedly on the remote control to
select the tuner source. The word "FM" will be showed on the display.

Tuning in a Station

Auto Tuning
/
Press and hold
frequency changes down or up automatically until a station is found.
The search may not stop at a station with a very weak signal.
Manual Tuning
Press / on the unit or
frequency until you find the station you want.
With FM radio it may be necessary to fine tune each station by pressing
on the remote control repeatedly. Each press will adjust the frequency by 0.05MHz. If reception is still
poor adjust the position of the aerial or try moving the radio to another location.
Preset Tuning
After the stations are preset (for details, please refers to the section "Presetting Stations"
below), repeatedly press the ALBUM/PRESET / buttons on the remote control to select
the desired preset number. Its band and frequency are displayed on the front panel.

Audio Mode

Press REF/SHUF button on the unit or remote control to switch between MONO and
STEREO mode.

Presetting Stations

You can store up to 20 of your favourite stations to the memory. This will enable you to
access your favourite stations quickly and easily.
Automatically
Press and hold PROGRAM for a few seconds. The word 'AUTO' will briefly appear on the
display. The unit will automatically search and store the first 20 radio stations it finds.
on the unit or /
/ on the remote control repeatedly to change the
on the remote control for a few seconds, the
/ on the unit or /
23