Vivo MOUNT-V002G Instruction Manual
Vivo MOUNT-V002G Instruction Manual

Vivo MOUNT-V002G Instruction Manual

Pneumatic arm dual monitor wall mount

Advertisement

Quick Links

Pneumatic Arm Dual Monitor Wall Mount
Instruction Manual
SKU: MOUNT-V002G
Scan the QR code with your mobile device or follow the link
for helpful videos and specifications related to this product.
https://vivo-us.com/products/mount-v002g
GET IN TOUCH | Monday-Friday from 7:00am-7:00pm CST
help@vivo-us.com
www.vivo-us.com
Chat live with an agent!
309-278-5303

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the MOUNT-V002G and is the answer not in the manual?

Questions and answers

Summary of Contents for Vivo MOUNT-V002G

  • Page 1 Pneumatic Arm Dual Monitor Wall Mount Instruction Manual SKU: MOUNT-V002G Scan the QR code with your mobile device or follow the link for helpful videos and specifications related to this product. https://vivo-us.com/products/mount-v002g GET IN TOUCH | Monday-Friday from 7:00am-7:00pm CST help@vivo-us.com...
  • Page 2 CAUTION! DO NOT INSTALL INTO DRYWALL ALONE. VERIFY YOUR WALL CONSTRUCTION. USE WOOD STUDS TO MOUNT. We include mounting for brick and concrete walls. If unsure, please contact us at vivo-us. com, email at help@vivo-us.com, or call us at 309-278-5303.
  • Page 3 ASSEMBLY STEPS STEP 1 OPTION A: Wood Wall Use a pencil to mark drilling location for wood beam and drill 2.2” deep holes using 3/16”bit. Use of a stud finder is recommended. Mount arm (A) to wall using screws (W-A) and washers (W-C). Do NOT use anchors (W-B) for wood beam installation.
  • Page 4 STEP 2 Press covers (B) into screw holes. STEP 3 Install screws (M-A) or (M-B) with washers (M-C) in top two holes of the monitor, leaving 3mm of space between the screw heads and the monitor. Tighten using the 5mm Allen Wrench (C). Hang monitor over top two slots of VESA plate, install two bottom screws, and then tighten top screws using Allen Wrench (C).
  • Page 5 STEP 4 Tighten the socket screw if the joints are making a popping sound. Adjust arm tension by turning screw with Allen wrench (C). Turn clockwise to reduce tension and turn counterclockwise to increase tension. The tension should be just enough to hold your monitor In place without lifting itself up. If needed, adjust bolts on the sides of the hinge behind the VESA plate to tighten or loosen the tilt angle.
  • Page 6 STEP 6 Insert cables and replace covers while making sure the cables have enough slack to allow enough free movement of the arm.
  • Page 7 Adjust as Desired...
  • Page 8 - 92% within < 3hr www.vivo-us.com : < 15 M AVG. RESOLUTION TIME (within office hrs) Chat live with an agent! : 5M 4S 309-278-5303 AVG. RESOLUTION TIME (within office hrs) FOR MORE VIVO PRODUCTS, CHECK OUT OUR WEBSITE AT: www.vivo-us.com...

Table of Contents