Scandomestic BIF 293 User Manual page 32

Mounting the fascia doors
Fig. 4 - Aligning the decor door
Close the door and check the
alignment with the other unit doors.
Adjust the decor door by screwing or
unscrewing the adjustment bolts for
vertical adjustment and by the help of
the slots on the fixing bracket for other
Fig 4
directions. Lock the screws into place
as shown in Fig. 4.
Fitting the decor door base fixings
With the appliance door open, locate the
metal decor door base fixing
brackets and screw the fixings to the decor
door. You may need to
remove and re-fit these brackets
depending upon the decor door
used.
Fitting the decorative cover
Re-fit the decorative cover, that you
removed in the first step, on to
the decor door fixing bracket.
Check that the whole door assembly
operates smoothly and that the
door seal of the freezer is still creating a
seal.
Ensuring the door seals correctly:
It is normal for the seal to be compressed after the door has been
reversed.
With the door closed, use a hair dryer to expand the seal and fill the
gap between the door and the body of the appliance.
Take care not to use the hair dryer too close to the appliance, which
could damage the seal. A distance of approximately 10cm should be
adequate.
When completed, allow the seal and door to cool before touching them.
Once done, the seal will remain in position.
18