Introduction; Qualified Persons; Read This Instruction Sheet; Retain This Instruction Sheet - S&C IntelliRupter PulseCloser Fault Interrupter Operation

Introduction

Qualified Persons

Read this
Instruction Sheet
Retain this
Instruction Sheet

Proper Application

Special Warranty
Provisions
2 S&C Instruction Sheet 766-540
Only qualified persons who are knowledgeable in the installation, operation, and
maintenance of overhead and underground electric distribution equipment, along
with all associated hazards, may install, operate, and maintain the equipment covered
by this publication . A qualified person is someone who is trained and competent in:
• The skills and techniques necessary to distinguish exposed live parts from nonlive
parts of electrical equipment
• The skills and techniques necessary to determine the proper approach distances
corresponding to the voltages to which the qualified person will be exposed
• The proper use of special precautionary techniques, personal protective equipment,
insulated and shielding materials, and insulated tools for working on or near exposed
energized parts of electrical equipment
These instructions are intended ONLY for such qualified persons . They are not
intended to be a substitute for adequate training and experience in safety procedures
for this type of equipment .
Thoroughly and carefully read this instruction sheet and all materials included in
the product's instruction handbook before installing or operating the IntelliRupter
PulseCloser Fault Interrupter . Familiarize yourself with the Safety Information
and Safety Precautions on pages 4 and 5 . The latest version of this publication is
available online in PDF format at sandc.com/en/support/product-literature/ .
This instruction sheet is a permanent part of the IntelliRupter® fault interrupter.
Designate a location where you can easily retrieve and refer to this publication.
The equipment in this publication is only intended for a specific application . The
application must be within the ratings furnished for the equipment . Ratings for the
IntelliRupter fault interrupter are listed in the ratings table in Specification Bulletin
766-31 .
The standard warranty contained in S&C's standard conditions of sale, as set forth in
Price Sheets 150 and 181, applies to the IntelliRupter fault interrupter, except that the
first paragraph of the said warranty is replaced by the following:
(1) General: The seller warrants to the immediate purchaser or end user for a period of
10 years from the date of shipment that the equipment delivered will be of the
kind and quality specified in the contract description and will be free of defects of
workmanship and material. Should any failure to conform to this warranty appear
under proper and normal use within 10 years after the date of shipment, the seller
agrees, upon prompt notification thereof and confirmation that the equipment has
been stored, installed, operated, inspected, and maintained in accordance with
the recommendations of the seller and standard industry practice, to correct the
nonconformity either by repairing any damaged or defective parts of the equipment
or (at the seller's option) by shipment of necessary replacement parts. The seller's
warranty does not apply to any equipment that has been disassembled, repaired,
or altered by anyone other than the seller. This limited warranty is granted only
to the immediate purchaser or, if the equipment is purchased by a third party for
installation in third-party equipment, the end user of the equipment. The seller's
duty to perform under any warranty may be delayed, at the seller's sole option, until
the seller has been paid in full for all goods purchased by the immediate purchaser.
No such delay shall extend the warranty period.
WARNING
NOTICE
WARNING