Teltonika FMT100 Installation Manual

Teltonika FMT100 Installation Manual

Hide thumbs Also See for FMT100:

Advertisement

Teltonika FMT100 GPS TRACKER INSTALLATION GUIDE
Additional configuration
notes if using the device
on our software platform.
1.
Clean surface of vehicle battery.
2.
Peel off sticky pad cover
3.
Stick device to top of battery
4.
Connect Black wire to Negative battery terminal.
5.
Connect
Red
(cable exit point towards front of the vehicle
wire to
Positive
battery terminal.
)

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the FMT100 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Teltonika FMT100

  • Page 1 Teltonika FMT100 GPS TRACKER INSTALLATION GUIDE Additional configuration notes if using the device on our software platform. Clean surface of vehicle battery. Peel off sticky pad cover Stick device to top of battery (cable exit point towards front of the vehicle Connect Black wire to Negative battery terminal.
  • Page 2 NOTES FOR SETTING IGNITION SENSE There are 2 options for detecting ignition on/off 1. Board Voltage – Device automatically detects voltage change when engine is switched on/off and sets the ignition status accordingly. (On some vehicles this feature can provide false readings such as auto stop/start technology etc in which case select option 2 (Movement sense) 2.
  • Page 3 TRACKING INTERVAL SETTINGS You can change the data upload settings in the software platform. If connecting remote immobilise feature we recommend setting the ‘idle’ time interval to 30 seconds. Always ensure you tick the box marked ‘Enable the sleep mode on idle’ which switches the GPS module off when parked to preserve the vehicle battery charge level.
  • Page 4 HARSH DRIVING MONITOR You can alter the sensitivity for the ‘harsh driving’ alerts in the platform device settings tab.

Table of Contents