Silvercrest SRR 3.7 C3 Operating Instructions Manual page 85

3) Clean all parts under running water and then allow them to dry fully.
4) Reassemble the cutting unit
guidance:
Place the three shaving heads in the recesses of the cutting
–
unit
heads rest on the catches in the opening.
Place the round blades into the shaving heads with the blade
–
tips to the front.
Press the two tabs of the retainers together and place them
–
back into the catches of the cutting unit
The cutting unit
5) Remove loose hairs from the shaver with the brush
6) Replace the cutting unit
into place and is seated firmly.
■ Clean the housing with a moist cloth.
SRR 3.7 C3
. Ensure that the notches on the edge of the shaving
is now reassembled.
. Use the following illustrations for
on the shaver. Ensure that it snaps
and release the tabs.
.
GB │ MT │
81 ■