Mechanical Adjustment; Presser Bar Height - ELNA easy cover Service Manual

Mechanical Adjustment

Should be
parallel.
t
w
q
e
r
4.7–5.3 mm
Should not interfare

1. Presser Bar Height

The distance between the bottom of the presser foot in
up position and the needle plate should be 4.7–5.3 mm.
z Remove the face plate and front cover.
x Remove the setscrews q, and lamp set plate w.
c Raise the presser foot and loosen the setscrew e.
Move the presser bar r up or down to set the
presser foot height to 5 mm.
v Tighten the setscrew e firmly.
NOTE:
Make sure that the presser foot should be parallel to
the feed dog slots t in the needle plate and should not
interfare with the needles.
b Attach the lamp set plate, front cover and face plate.
6