HP ProCurve 6400cl Series Access Security Manual page 262

Traffic/Security Filters
Filter Types and Operation
ProCurve(config)# filter source-port 2-6,8,9,12-26 named-filter web-only
ProCurve(config)# filter source-port 7,10,11 named-filter accounting
ProCurve(config)# filter source-port 1 named-filter no-incoming-web
ProCurve(config)#
ProCurve config)# show filter (
Traffic/Security Filters
IDX Filter Type | Value
--- ------------ + ------------------ -
1 Source Po rt | 2
2 Source Port | 3
3 Source Port | 4
4 Source Port | 5
5 Source Port | 6
6 Source Port | 8
7 Source Port | 9
8 Source Port | 12
20 Source Port | 24
21 Source Port | 25
22 Source Port | 26
23 Source Port | 7
24 Source Port | 10
25 Source Port | 11
26 Source Port | 1
9-10
The show filter command shows what ports have filters applied.
Using the IDX value in the show filter command, we can see how traffic is
filtered on a specific port (Value).The two outputs below show a non-
accounting and an accounting switch port.
Indicates the port number or port-
trunk name of the source port or trunk
assigned to the filter.
An automatically assigned index
number used to dentify the filter for i
a detail ed information sting. A filter li
retains its assigned IDX number for
as long as the filter exists n the i
switch. The switch assigns the
lowest availab e IDX number to a new l
filter. This can result in a newer filter
having a lower IDX number than an
older filter if a previous (source-port
or named source-port) filter de etion
created a gap in the filter sting. li
l