How To Use The Dishwasher - Bauknecht GSF 5243 Manual

94000-gb.fm5 Page 17 Thursday, September 13, 2001 4:13 PM
Close the dishwasher door and turn on
the water tap.
1. Press the ON/OFF button to switch on the
dishwasher. One of the programme indicator
lamps will illuminate.
2. Select the required programme by pressing
the programme button. The corresponding
indicator lamp will illuminate.
If required, select any additional functions.
3. Press the Start button to start the selected
wash programme. The corresponding
indicator lamp will illuminate. Once set, the
programmed data cannot be altered by
turning the programme selector knob or
pressing the buttons.
Note: Once the Start button has been
pressed, the dishwasher memorises all the
programmes selected. The selected
programmes are also saved in the event of
power failure.
4. To change the programme selected, press
the Start button for about 5 seconds until the
Start indicator lamp switches off. Select a
new programme using the programme
button and press the Start.
5. The End indicator lamp (if fitted) illuminates
briefly and the Start indicator lamp switches
off to indicate the end of the programme.
6. Press the ON/OFF button to switch off the
dishwasher (only after the End indicator lamp
has switched on or the Start indicator lamp
has switched off). All the indicator lamps
switch off.
Note: If the dishwasher is switched off
during a wash programme, when switched
on again the dishwasher resumes the wash
cycle from where it was interrupted.
Open the door and unload first the lower rack
and then the upper one.

HOW TO USE THE DISHWASHER

1
2
3
4
5/6
17