BQS BCAFIX 123 ST-2 Instruction Manual page 15

For the safety of your child, before every journey in the car check that...
• the child safety seat is engaged on both sides with the ISOFIT locking
arms (15) in theISOFIX attachment points 01 and that both green safety
buttons 04 are completely green.
• the child seat is firmly installed in the vehicle.
• the Top Tether (13) is tightly tensioned over the backrest of the car seat
and the tension indicator (18) is green.
• the straps of the child safety seat are close to the body without
constricting the child.
• the shoulder belts (08) are correctly adjusted and the straps are not
twisted.
• the shoulder pads (19) are at the same level as your child's shoulders.
• the buckle latches (20) are engaged in the harness buckle (21).
4.2 GROUP 1 (9-18 kg). Vehicle belt+ 5-Point Harness
1. Make sure that the child seat's 5-point harness is installed correctly (see
section 7).
2. Follow the steps in section 3.2 ( to adjust headrest).
3. Place the child seat facing in the direction of travel on the vehicle seat.
4. Pull the vehicle belt (22) out and guide it through the belt guides of the
child seat. Make sure that the belt is not twisted (fig.20).
5. Engage the buckle tongue in the vehicle seat buckle (29) this should make
a click noise (fig.21).
6. on the side opposite the car seat belt buckle, press lever (24) and hold
down and insert diagonal belt in belt lock-off (25) (fig.22).
7. Apply your body weight to the child seat (kneel into the seat). At the same
time pull the diagonal belt strongly to tighten .
8. Follow the steps in section securing your child with 5-point harness.
For the safety of your child, before every journey in the car check that...
• the child seat is firmly installed in the vehicle.
• the belt is not twisted.
• the diagonal belt is only clamped by the lock-off which is located on the
opposite side from the car seat belt buckle.
• the straps of the child safety seat are close to the body without
constricting the child.
• the shoulder belts (08) are correctly adjusted and the straps are not twisted.
• the shoulder pads (19) are at the same level as your child's shoulders.
• the buckle latches (20) are engaged in the harness buckle (21).
28
4.3 GROUP 2 (15-25 kg). Vehicle belt+ Top tether +5-Point Harness
1. Follow the steps in section 4.2 (to fix child seat by three point belt).
2. Take the top tether and if required, lengthen the belt by pressing the top
tether brake button to release the strap, pulling to adjust as necessary
(fig. 23).
3. Hook the snap hook (17) into the Top Tether anchoring point recommended
in your vehicle owner's guide (fig.24).
tIP: Look for this symbol in your vehicle.
4. To tension the top tether, remove any slack by pulling on the free end of
strap until it is suitably tightened. The top tether will be properly tightened
when the tension indicator turns completely green (fig.25/A).
5. Follow the steps in section securing your child with 5-point harness.
For the safety of your child, before every journey in the car check that...
• the child seat is firmly installed in the vehicle.
• the belt is not twisted.
• the Top Tether (13) is tightly tensioned over the backrest of the car seat
and the tension indicator (18) is green.
• the diagonal belt is only clamped by the lock-off which is located on the
opposite side from the car seat belt buckle.
• the straps of the child safety seat are close to the body without
constricting the child.
• the shoulder belts (08) are correctly adjusted and the straps are not twisted.
• the shoulder pads (19) are at the same level as your child's shoulders.
• the buckle latches (20) are engaged in the harness buckle (21).
4.4 GROUP 2 (15-25 kg) & GROUP 3 (22-36 kg) Vehicle belt
1. Make sure that the child seats 5-point harness is removed correctly (see
section 6).
2. Follow the steps in section 3.3 (to adjust headrest).
3. install car seat on vehicle.
• Option A, Install child seat with ISOFIX connectors and Top tether.
1. Take the Top Tether and lay it over the child seat.
2. Place the child seat facing in the direction of travel on the vehicle seat.
3. Grasp the child seat with both hands and slide the two locking arms
(15) firmly into the insert guides (02) until the locking armsengage with a
www.babyqs.com
BCA 123 29