Table of Contents
Advertisement
Wiring
Digital input wiring
examples
RDIO-01 User's manual
2
0.5 to 1.5 mm
appropriate voltage rating should be used for digital
signals.
WARNING! According to international standards,
applying voltages below 50 V (DC or AC) and above
150 V (AC or DC) simultaneously to the digital inputs
and/or outputs of the RDIO-01 is not allowed.
Additionally, only voltages of the same nominal level
should be applied simultaneously to digital inputs DI2
and DI3 due to reduced isolation voltage.
Note: Do not route signal cables parallel to power
cables.
110...230 V AC ±10%
24...250 V DC
(polarity unimportant)
twisted pair unshielded cable with an
Chapter 3 – Installation
RDIO
DIxA
DIxB
RDIO
DIxA
DIxB
3-5
Advertisement
Table of Contents
