Environmental Protection - Metabo KHA 18 LTX BL 24 Quick Original Instructions Manual

9. Accessories
Only use original Metabo battery packs and
Metabo accessories.
Use only accessories that fulfil the requirements
and specifications listed in these operating
instructions.
Fit accessories securely. If the machine is operated
in a holder: secure the machine well. Loss of
control can cause personal injury.
Batter chargers: ASC Ultra, ASC 30-36, etc.
Battery packs with different capacities. Only
use battery packs with voltage suitable for your
power tool.
Order no.: 6.25346 ... 3.5 Ah (LiHD)
Order no.: 6.25342 ... 5.5 Ah (LiHD)
Order no.: 6.25345 ... 7.0 Ah (LiHD)
etc.
Order no.: 6.25591.... 4 Ah (Li-Ion)
Order no.: 6.25592.... 5.2 Ah (Li-Ion)
etc.
Integrated dust extraction ISA 18 LTX 24
Order no.: 6.31341
For a complete range of accessories, see
www.metabo.com or the catalogue.
10. Repairs
Repairs to electrical tools must be carried out by
qualified electricians ONLY!
If you have Metabo electrical tools that require
repairs, please contact your Metabo service
centre. For addresses see www.metabo.com.
You can download spare parts lists from
www.metabo.com.

11. Environmental Protection

Do not allow battery packs to come into contact with
water!
To protect the environment, do not dispose of
power tools or battery packs in household
waste. Observe national regulations on
separated collection and recycling of disused
machines, packaging and accessories.
Before disposal, discharge the battery pack in the
power tool. Prevent the contacts from short-circuiting
(e. g. by protecting them with adhesive tape).
12. T echnical Specifications
Explanation of details on page 3. Subject to
changes serving technical progress.
U = Voltage of battery pack
n = No-load speed
1
n = Load speed
2
dia = Maximum drill diameter
.max
s = Maximum impact rate
max
W = Single impact force
m = Weight with smallest battery pack
D = D=Collar diameter
Measured values determined in conformity with EN
60745.
Direct current
The technical specifications quoted are subject to
tolerances (in compliance with the relevant valid
standards).
Emission values
Using these values, you can estimate the
emissions from this power tool and compare these
with the values emitted by other power tools. The
actual values may be higher or lower, depending
on the particular application and the condition of
the tool or power tool. In estimating the values, you
should also include work breaks and periods of low
use. Based on the estimated emission values,
specify protective measures for the user - for
example, any organisational steps that must be put
in place.
Vibration total value (vector sum of three
directions) determined in accordance with EN
60745:
a = Vibration emission value (hammer
h, HD
drilling into concrete)
a = Vibration emission value (chiselling)
h, Cheq
K = Uncertainty (vibration)
h,HD/Cheq
Typical A-effective perceived sound levels::
L = Sound pressure level
pA
L = Acoustic power level
WA
K , K = Uncertainty
pA WA
During operation the noise level can exceed 80
dB(A).
Wear ear protectors!
ENGLISH en
11