Appendix A: Optional Heated P-Trap Installation - Suburban DynaPack S Series Architects And Engineers' Manual

APPENDIX A: OPTIONAL HEATED P-TRAP INSTALLATION

The Dynapack condensate drain system is designed to be installed in a conditioned space. To prevent freezing
of the drain condensate in the P-Trap, the installation location should not be exposed to freezing conditions. In
installations where the drain system is exposed to freezing conditions, we offer an optional heated P-Trap which
is available for purchase. The part number for the heated P-Trap installation kit is K/10348.
Instructions for installing heated P-Trap kit:
1. Turn power off from main disconnect.
2. Remove existing P-Trap drain.
3. Remove middle & top doors and the control box
cover.
4. Slip extruded (black) rubber drain hose back into
the unit.
5. Route wires/heat cable on the supplied drain trap
through the bushing for the rubber drain hose.
6. Route wires along existing wires up to Top/Line side
of contactor.
HEATED P-TRAP
WITH BARBED FITTING
MAY NEED TO SLIP ELBOW &
BARBED FITTING OFF P-TRAP
TO INSERT INTO RUBBER HOSE
Please consult the Suburban Manufacturing website at www.SuburbanManufacturing.com for the latest product literature. Detailed dimensional data is
available upon request. A complete warranty statement can be found in each product's Installation/Operation Manual, on our website. As part of the
Suburban continuous improvement program, specifications are subject to change without notice.
Manufactured by:
NOTE: ROUTE HEAT CABLE IN
HOLE/BUSHING WITH RUBBER
DRAIN TUBE (MAY NEED TO
PUSH DRAIN TUBE BACK OUT
OF THE WAY TO RUN CABLE
THROUGH HOLE) SEE STEP 4 & 8
WIRES/HEAT CABLE
APPROX. LOCATION
OF WIRES
P.O. Box 400
156 Seedling Drive
Ph: 229-273-3636
Email: marvair@airxcel.com
7. Wire as per drawing ES48000 sent with the kit to
contactor & ground lug.
8. Re-insert rubber drain hose through bushing with
supplied Wires/Heat cable.
9. Insert barbed fitting on the P-Trap into rubber drain
hose (soapy water can be used for easy installation).
10. Align P-Trap as needed for existing drain plumbing.
11. Use wire ties to secure wires to existing wire/leads.
12. Re-check connections.
13. Replace control box cover, middle & top doors.
14. Unit is ready to be powered on.
DETAIL B
SCALE 1 : 2
CONNECT TO EXISTING
DRAIN PLUMBING
•
Cordele, GA 31010
•
Cordele, GA 31015
•
Fax: 229-273-5154
44
(BLACK) RUBBER DRAIN HOSE
B
Suburban DynaPack A&E Manual 12/2017 Rev.4
STEPS FOR INSTALLING
1. TURN POWER OFF F
2. REMOVE EXISTING P
3. REMOVE MIDDLE &
4. SLIP EXTRUDING (BL
5. ROUTE WIRES/HEAT
BUSHING FOR RUBB
6. ROUTE WIRE ALONG
7. WIRE AS PER DRAW
8. RE-INSERT RUBBER D
WIRES/HEAT CABLE.
9. INSERT BARBED FITTI
USED FOR EASY INSTAL
10. ALIGN P-TRAP AS N
11. WIRE TIE WIRES TO
12. RE-CHECK CONNE
& TOP DOORS.
UNIT IS READY TO BE P